PTZ5A4M-25X IVS and Tracking ?
- Thread starter ponyrider127
- Start date
Also On global sensitivity I have it set at 8
I will say if its picking up IVS trips well but losing target after it starts to track, and assuming its not an obstruction issue (which you could have there with the fence)
I see the same behavior.
Its something Dahua needs to look at and see if they can fix in FW. Its worse tyhan any other PTZ I've owned in that regard
I will say if its picking up IVS trips well but losing target after it starts to track, and assuming its not an obstruction issue (which you could have there with the fence)
I see the same behavior.
Its something Dahua needs to look at and see if they can fix in FW. Its worse tyhan any other PTZ I've owned in that regard
Here is a trip
I just picked up. When I went to check play back it did not mark as a intel just general.
I just picked up. When I went to check play back it did not mark as a intel just general.
IVS tripped, it recorded.
Played it back on what? Show me. Thats an Intel (IVS) activation clearly.
You may not have settings correct to note it as such
It is off. It does not show a intel trip. I have to go find it in general.
Attachments
On the IVS rule ON the CAMERA UI (not the NVR) you have to have Record enabled under Event Linkage
On the NVR you have to have IVS setup to record under Storage/Schedule- for the correct channel and all days
In SmartpSS you need to have ALL checked bottom left on playback
On the NVR you have to have IVS setup to record under Storage/Schedule- for the correct channel and all days
In SmartpSS you need to have ALL checked bottom left on playback
On NVR I had Intel and general. I added alarm. On Camera GUI I added on event linkage to send command. we will see in the morning what I have.
No need to add alarm on the NVR
You were missing the Record on Event Linkage on the camera. It should work now
You were missing the Record on Event Linkage on the camera. It should work now