New Bullet Camera Installation Issue, Stiff Base Adjustment

[sunny0101786]

I tried to install a new bullet camera and I noticed that if I keep the marker notch (the indicator meant to stay on the top side) facing up, the view angle points to the opposite side of where the camera can tilt. I tried twisting the base part, which makes a clicking noise when we spin it but it so much stiff not even moving a bit. I was worried it might break if I applied too much force. The other camera I checked twists very easily, but this one feels stiff. Do you know the correct way to make it twist more easily? What would you suggest to make it work properly?

 

[wittaj]

You need to unscrew the lock screw a lot.

And if the rotation is a lot, then the ones behind the base as well.

Under normal unscrewing of the set screw, it is designed to only move a little like 3 clicks, so unscrewing it more will let it move more.

 

[Ri22o]

Which model of bullet do you have?

 

[sunny0101786]

You need to unscrew the lock screw a lot.

And if the rotation is a lot, then the ones behind the base as well.

Under normal unscrewing of the set screw, it is designed to only move a little like 3 clicks, so unscrewing it more will let it move more.

Loosening the back plate screws a bit worked. Thanks for the help!

 

[sunny0101786]

Which model of bullet do you have?

hfw7442h-z4-x

 

[sunny0101786]

View attachment 20250909040744370.mp4