R0 / DS-2CD2x32 BrickfixV2 brick recovery and full upgrade tool - enhanced.

Hello, any instruction to change CN to EN for DS-2CD3366WDA4-L, V5.7.5 build 241103.
Many thanks
 
Last edited:
I just followed these steps to update a bricked DS-2CD2432F-IW to V5.4.5build 170401!

So is there a way I can update my other cameras that are still running V5.2.5build 141201 and not have them be bricked in the process so that I can avoid the brickfixv2 brick recovery process?
 
Bionic said:
I just followed these steps to update a bricked DS-2CD2432F-IW to V5.4.5build 170401!
Click to expand...
Well done!

Bionic said:
So is there a way I can update my other cameras that are still running V5.2.5build 141201 and not have them be bricked in the process so that I can avoid the brickfixv2 brick recovery process?
Click to expand...
If they are not China region cameras with hacked firmware - then the normal upgrades should work OK.
A clue may be in the serial numbers - CCCH usually indicates Chinese.
 
alastairstevenson said:
If they are not China region cameras with hacked firmware - then the normal upgrades should work OK.
A clue may be in the serial numbers - CCCH usually indicates Chinese.
Click to expand...
So I just checked, and they have CCCH in the serial number. So I need to do this entire process for all of them? Or since are there some short cuts that I can take since they are all the same model number?
Perhaps I can use the same mtd6ro_mod file for all of them?

Since the others are not bricked maybe the steps to do this are not exactly the same as a bricked camera? maybe there is a faster way to update all of them?

@EMPIRETECANDY Maybe I should just replace them. What would be the recommended replacement for the DS-2CD2432F-IW cameras? They provide enough resolution and features for my needs. The only issue I have with them is that some of them the IR no longer works... Other than that they work fine.
 
Last edited:
Bionic said:
So I just checked, and they have CCCH in the serial number. So I need to do this entire process for all of them? Or since are there some short cuts that I can take since they are all the same model number?
Perhaps I can use the same mtd6ro_mod file for all of them?

Since they others are not bricked maybe the steps to do this are not exactly the same? maybe a faster way to update all of them?
Click to expand...
Read this blog post, download the service firmware, and simply update your camera through the web interface. Your camera will be permanently converted to the European model.
 
  • Like
Reactions: alastairstevenson
Hello, I have Ds-7616-e2/8p with V3.4.106 build 191009. I have ds-2cd2032i camera. I have downloaded the 5.30 from EU site and probable brick it. I have updated with brickfixV2CN . the problem is i can't access with telnet with 192.0.0.64. Did they disable with telnet with latest firmware?IMG_9788.jpgIMG_9784.jpeg
 
softfree said:
the problem is i can't access with telnet with 192.0.0.64. Did they disable with telnet with latest firmware?
Click to expand...
Is the camera still connected to the NVR PoE port? And the PC on the LAN?
If so, the camera isn't directly accessible.

If the camera is still connected to the NVR, either connect the PC to an unused NVR PoE port, or connect the camera to the same LAN as the PC and power the camera with 12v.

And give the PC an IP address in the same range as the camera - which looks like 192.168.254.2
 
You must log in or register to reply here.
Top Bottom