Trying to figure out this memory leak

[crespoh69]

OS: Win 10
Memory: 8GB-16GB
Cameras: 6
BI Version: 5.9.1.6

I'm currently running version 5.9.1.6 on a bare metal VM that seemed to have been working for a couple of months then all of a sudden it's started to crap out. I've gone ahead and isolated to what appears to be the camera I added back in November, an Annke FCD600. I'm currently running 6 cameras, all of the other ones are Annke C500's and 1 Reolink Duo 3. I've tested the VM with memory ranging from 8GB to 16GB but after a couple of days it starts to eat more and more memory until Windows hangs.

Has anyone used the FCD600 and experienced similar issues? Any workaround you found? I normally copy another cam when adding new ones but I've also tried to just add this one from scratch with the same results. I'm unsure if there's a particular setting on the cam end that's killing things but am also unaware of how I'd go about troubleshooting further. I did also go and physically test the line using a microscanner2 with no issues shown on the lines going up to the switch or the camera so I'm a bit at a loss right now.

 

[bp2008]

I run several FCD600 and they are all fine.

If hardware acceleration is enabled in Blue Iris, turn that off.
In Blue Iris Status > Cameras, you should have hyphens under the HA column.

 

[bp2008]

As another troubleshooting step you could try swapping the video codec (h.264 vs h.265) or lowering the main stream resolution, to see if maybe Blue Iris just had a decoding bug only affecting some streams.

 

[crespoh69]

As another troubleshooting step you could try swapping the video codec (h.264 vs h.265) or lowering the main stream resolution, to see if maybe Blue Iris just had a decoding bug only affecting some streams.

I'll try the HA tip, I went ahead and did it with all of them, as for h.264 already tried that on that particular cam. We'll see if anything takes.