I've never had to add an external device like this strobe light to an IP camera before so i need your guidance Based on the IPC-B54IR-Z4E-S3 specs, it has a 1 channel out: wet contact, 300mA 12V DC, which I think means it can control a device like a strobe light, as long as the strobe is 12V DC and draws less than 300mA. Is that correct ? If that does not work i guess i could add one of these Relay
I know the camera has ALARM_OUT, which outputs a signal to the alarm device, and ALARM_OUT_GND for ground. Since the wires are quite small, what type of terminal or connector do you use to connect them to external wiring?
I know the camera has ALARM_OUT, which outputs a signal to the alarm device, and ALARM_OUT_GND for ground. Since the wires are quite small, what type of terminal or connector do you use to connect them to external wiring?