PTZ5A4M-25X Tracking issues - Dahua SD5A425GA-HNR

FlipNJ said:
Haven't set it up yet bc its crappy here today but happy that at least, its a different FW than your original one that was an issue.
Click to expand...

Its not fixed yet.

It still tracks car, trash cans, and the occasional alien.
It also "hunts" a lot and misses targets after being activated - just misses, like someone shooting a rifle that hasnt been zero'd. Seeing a target at 50 yds and then when pulling the trigger misses by 5ft, most often to the left
 
bigredfish said:
The image is better by virtue of the sensor, yes
Click to expand...
All set up. So far I love it. Seems to ignore trash cans but still kind of considers mailbox posts as ppl. One thing that is puzzling me is how to fix the object closer to the center when tracking. It is kind of slow and initially tracks the rear of a car. Tried reducing target size to 28 but it still does it. Any tips?
View attachment Recording 2026-04-05 121230.mp4
 
It tends to miss left when acquiring even after initial activation and fades after acquisition to the left a LOT

Faster targets of course make this worse.

As close as you are it won’t be too bad.
 
  • Like
Reactions: FlipNJ
My Ptz is now giving me random disconnect errors and stuttering issues on Blue Iris playback. Hope its not end of life coming soon. I had it on a 5 port poe+ switch in my shop since I purchased it. I have it now ( last 3 weeks) powered by the DC power brick that came with it. Same errors. New 8' of 6e cable coming soon.
Any word on newer firmware be available?
 
juliand said:
My Ptz is now giving me random disconnect errors and stuttering issues on Blue Iris playback. Hope its not end of life coming soon. I had it on a 5 port poe+ switch in my shop since I purchased it. I have it now ( last 3 weeks) powered by the DC power brick that came with it. Same errors. New 8' of 6e cable coming soon.
Any word on newer firmware be available?
Click to expand...

Have you tried a factory reset and set up by scratch?

Do you have an SD card in the camera to confirm it is a camera issue and not BI issue (perhaps from an update)?
 
You must log in or register to reply here.
Top Bottom