Figures - I'm leaving for three weeks today and I lose video on one of the most critical cameras on my system.
Not sure if there is any correlation, but yesterday I set up an old iPad with ivms-4500 for my employee to monitor while off site, and that is when I started noticing the issue.
At first it would drop, and then I would be able to find it on the camera list and add it back.
Today, I can't even do that.
I have a few hours this morning before I leave, and other than perhaps a bad termination or port on the POE switch ( Don't have a tester handy, should I just install 2 new RJ45's before trying a new port, or try the port first?), anything else I should try?
ETA : Camera is mounted in car wash tunnel at exit wall. Humid environment but has minimal( maybe mist) to zero direct water contact.
Thanks guys
Not sure if there is any correlation, but yesterday I set up an old iPad with ivms-4500 for my employee to monitor while off site, and that is when I started noticing the issue.
At first it would drop, and then I would be able to find it on the camera list and add it back.
Today, I can't even do that.
I have a few hours this morning before I leave, and other than perhaps a bad termination or port on the POE switch ( Don't have a tester handy, should I just install 2 new RJ45's before trying a new port, or try the port first?), anything else I should try?
ETA : Camera is mounted in car wash tunnel at exit wall. Humid environment but has minimal( maybe mist) to zero direct water contact.
Thanks guys