Hikvision DS-7716NI-14/16P with board DS-80243

[ziubzia]

Is there anyway of hard resetting this NVR via the boards with jumpers etc? if not what is the best way to reset it as we no don't have the password. Any advice would be apreciated?

 

[alastairstevenson]

What's the firmware version on the NVR, as shown by Hikvision's SADP tool?

If you can get your hands on a Hikvision camera running firmware 5.3.0 to 5.4.1 this little trick often works :

P

Thread 'Alternative way of recovering HikVision NVR password'

Jun 11, 2019

Hello, I am @Pjlord from Carmel in California, and I am new to this board, but I have been working with a couple HikVision systems for several years now. Hopefully, I posted this in the right forum section.

Recently, I purchased a new home which had a HikVision system with 3 cameras installed. Unfortunately, the original owner could not remember the password. I need to thank @alastairstevenson for his help in troubleshooting this situation. Here are the details:

System setup:
NVR: DS-7604NI-E1/4P running Software Version V3.4.90build 161008
Cameras: 3 X...

• Pjlord

• 

Alternatively, you'll likely find a configuration reset command via the serial TTL console, the 4-pin connector like this example :

Hikvision NVR DS-7804N-E1/4P Bricked

Hello, i have NVR DS-7804N-E1/4P bricked when i flash wrong firmware DS-7604NI for it. So now it only boot to Logo then bip bip and auto restart. I tried flash TFTP very many time by set IP of my PC to 192.0.0.128 / subnet 255.255.255.0 and turn firewall is off. But no thing flashable although i...

ipcamtalk.com