Hi all, I have a Hikvision DS-7604NI-E1/4P (newest firmware) which I've had three cameras attached to for a few years, without issue. Two Hikvision dome cameras, and a basic IP camera recording the inside of a bird box. All detect and record motion perfectly well.
Just recently I bought an Annke NCPT 500 NightChroma NCPT500 3K Pan Tilt PoE Security Camera - ANNKE Store to fill the fourth channel, I intend to use it at the back of my house.
I've connected it to the NVR with POE, it's all working and being controlled just fine. But I can't get motion detection working. I can draw the area to be recorded, I can set the schedule, all that stuff - but it will only ever record continuously. Even with sensitivity at max, it doesn't appear to detect and record motion.
I've passed the point where I can return it, and tbh I think this is likely a compatibility issue, but before I go and buy a Hikvision camera that's probably going to work just fine, is there anything else I might try?
Just recently I bought an Annke NCPT 500 NightChroma NCPT500 3K Pan Tilt PoE Security Camera - ANNKE Store to fill the fourth channel, I intend to use it at the back of my house.
I've connected it to the NVR with POE, it's all working and being controlled just fine. But I can't get motion detection working. I can draw the area to be recorded, I can set the schedule, all that stuff - but it will only ever record continuously. Even with sensitivity at max, it doesn't appear to detect and record motion.
I've passed the point where I can return it, and tbh I think this is likely a compatibility issue, but before I go and buy a Hikvision camera that's probably going to work just fine, is there anything else I might try?
