FPS on main stream showing over what the camera is set to

dbrannon79 · 2023-08-12T03:38:51+00:00

Hello all, I'm not sure if this is the right place to post for this kind of issue, Mods please feel free to move if needed. I have been toying around with the cameras FPS/KEY settings trying to get them as close as possible to 15/1.00 in an effort to get the lag or camera delay down to a minimum. I have a total of 9 cameras and one live feed of my local weather radar (Father n law addicted to the weather) 5 of these cameras are IMOU cameras that are Dahau cameras under the hood ,one is a Anpviz camera, two are old cctv analog cameras using a usb capture device over MJPG and one is an older IP camera I had long before I got BI going. I was able to log into the Anpviz camera and set the frame interval to match the FPS without any issues and found an app called SmartPSS that allowed me to set the "I interval" for each of the IMOU (Dahau) cameras. all cameras are set to 15 FPS both main and sub streams along with matching frame interval / I intervals. My issue is when looking at the camera status window in BI, two of the IMOU cameras will auto increase the FPS on the main streams leaving the key side at a lower number. I highlighted the two cameras in question in the screenshot below. I also have some issues to work out with the "Front Left" camera as it seem to loose FPS, not sure why that's happening, I will try to address that one later. But of the 4 IMOU cameras, three are holding the 15/1.00 or staying very close to that where two don't seem to respond to me setting them at the 15 FPS / 15 frame interval for the main stream. on the sub stream all 5 seem to be responding well other than a bit of up and down swings here and there. below is also a screenshot of the setting I have all 5 of the IMOU cameras set at. maybe I missed something?