I bought a few of these to mount a few IPC-Color4K-T180 from Andy.
How do i make the spot in red water proof after i run a cat5e cable through it?
How do i make the spot in red water proof after i run a cat5e cable through it?
DH-PFA121 water proof?
- Thread starter cmx
- Start date
Consider these cable glands. You might find one to fit the G3/4" hole on the PFA-121 box.
33PCS Cable Gland Waterproof Kit White IP68, Plastic Cable Connectors Black Nylon Adjustable 3-18mm with Locknut and Washer,Electrical Conduit Fitting 1/4” 3/8”1/2”3/4” Strain Relief Cord Grip
Last edited:
As an Amazon Associate IPCamTalk earns from qualifying purchases.
Or if the NPT (National Pipe Thread) won't work, consider these metric sizes. You might find them in white somewhere. They're called "cable glands" or "cord strain reliefs".
TUPARKA Cable Gland Waterproof Adjustable 3-16mm Cable Connectors PG7 PG9 PG11 PG13.5 PG16 PG19 Plastic Cable Gland Joints with Gaskets (black)
As an Amazon Associate IPCamTalk earns from qualifying purchases.
In the specs of the junction box it says Pipe Thread G3/4” whatever size that really is.
The issue is even when you have the right one the hole is still to large as only one CAT5E cable is using it ......you need a size reducer.
I also make my own cables so i would pull it through before putting a connector on.
Last edited:
As an Amazon Associate IPCamTalk earns from qualifying purchases.
As I stated in my first post.In the specs of the junction box it says Pipe Thread G3/4” whatever size that really is.
I use several turns of self-curing rubber tape until it's snug, then cinch the collar down until it's tight.