Can I change the Native Home position on a cheap Chinese camera?

P03on3743rn3t

P03on3743rn3t

n3wb
Oct 28, 2019
15
0
Arizona
Hi fellow camera users,

I have a new SV3C WiFi PTZ camera in the HX series. I was forced to mount it about 90 degrees left (north) of where I want my primary viewing area (east). So it mostly looks at an area I don't care about.
Is there any way I change the primary view area to east instead of north.
To remount the camera facing east has other issues and is not really worth the effort.

I have tried many (apparently applicable) settings in BI and also in the camera's online application with limited success.
I can cause the camera to temporarily move to the east view by setting a PTZ position and using it in a cycle, but it always returns to the north view after a minute or so.

I am using version 5.9.9.59 BI.

Any help is greatly appreciated.
 
This would likely be set in the camera's settings and not BI. I had a Foscam PTZ I used as a baby monitor and was able to set presets in the UI, and then call out which one it would go to on start up. Can you post some screenshots of the camera's UI?
 
  • Like
Reactions: mat200
My first thought is to move it where you want it via the Monitor screen, and then click Submit to save it as a preset.

The question is then how to get it to return to that position by default on start up. Maybe look through the System options?
 
On dahua or hikvision cameras, they call it something like "park action" or "idle motion" or something like that, and allow you to choose a preset # to go to after X minutes.
 
  • Like
Reactions: looney2ns
Hi Ri22o and bp2008,

In the camera's UI, I was able to set the view I want and save it as a preset.
After scouring the menus the closest thing I could find was " Linkage preset " under the Alarm menu.
I've set that to the preset number I want, but I've yet to see the camera point to that area.

I'm going to try restarting the camera in BI to see if that helps.
Restarting the camera did nothing.

The camera still primarily looks at the original native view.
It will move to the desired preset when manually commanded to do so.
Other than setting a preset view, the changes made in the camera's UI did nothing else that I've seen so far.
 
You might be able to set a schedule in BI to call it to that preset every so often, basically keeping it there.
 
You must log in or register to reply here.
Top Bottom