Are these cameras not made for outside?

I

ingeborgdot

Pulling my weight
May 7, 2017
721
171
Scott City, KS
I have a DS-2CD2342WD camera. It is positioned under and eve up against the garage in a pretty sheltered place. We had rain last night and now there is water in the lens and it is blurring the view. I can see the water in the lens when I look at it. What kind of crappy camera did I buy? It is less than a year old. I thought these things were made for outdoor use??????? What can I do about it??
 
ingeborgdot said:
I have a DS-2CD2342WD camera. It is positioned under and eve up against the garage in a pretty sheltered place. We had rain last night and now there is water in the lens and it is blurring the view. I can see the water in the lens when I look at it. What kind of crappy camera did I buy? It is less than a year old. I thought these things were made for outdoor use??????? What can I do about it??
Click to expand...
the camera is either defective or your improperly installed it...ill bet the latter based on your post. Are you certain its inside and not on the outside?
fyi there are much better cameras in that price range.
 
Last edited:
Yes, I know. I have the Dahua cameras that you recommended and they are all fine. This one I purchased before I found this forum. No, it is not IMPROPERLY installed. How can a person not properly install a camera?
It is on the inside as I went to wipe it off and I can see it on the inside.
 
ingeborgdot said:
Yes, I know. I have the Dahua cameras that you recommended and they are all fine. This one I purchased before I found this forum. No, it is not IMPROPERLY installed. How can a person not properly install a camera?
It is on the inside as I went to wipe it off and I can see it on the inside.
Click to expand...
there are many ways to improperly install a camera - just one example is running the cable on the exterior and not using a drip loop. Sometimes though cameras are defective and water gets inside...take it down, dry it, replace the desiccant packet and tighten the screws.
 
Nope. No cables on the outside. Totally sealed. No water coming from the underhang could have dripped water to the cam. I'm trying to send a pic but have to figure it out on this site.
 
You see, it is pretty sheltered from the elements. The rain may have been blown onto the cam from wind but there is no way water got into the cam from anywhere other than the cam itself.
 
ingeborgdot said:
You see, it is pretty sheltered from the elements. The rain may have been blown onto the cam from wind but there is no way water got into the cam from anywhere other than the cam itself.
Click to expand...
then its defective and you need to do what I said in the earlier post.
 
ingeborgdot said:
You see, it is pretty sheltered from the elements. The rain may have been blown onto the cam from wind but there is no way water got into the cam from anywhere other than the cam itself.
Click to expand...

Kill power to it until you can take it down. Take it apart indoors, and let it dry for at least 24hrs. If the seals are bad, a little RTV silicone can fix it up when you re-install.
 
Since I hadn't opened it up yet I didn't know if there was a special size I needed or not. If I can dry them and reuse them, I'll do that but my question really is, how can I keep rain from getting in there again??? This should not happen. I may dry it out and sell it on ebay.
Also, are you (either fenderman or looney2ns) still recommending the Dahua IPC-HDW5231R-Z that you did earlier or has something new come in that you like better?
 
ingeborgdot said:
Since I hadn't opened it up yet I didn't know if there was a special size I needed or not. If I can dry them and reuse them, I'll do that but my question really is, how can I keep rain from getting in there again??? This should not happen. I may dry it out and sell it on ebay.
Also, are you (either fenderman or looney2ns) still recommending the Dahua IPC-HDW5231R-Z that you did earlier or has something new come in that you like better?
Click to expand...
This is an anomaly and the same can happen on the dahua - there is even a thread where it happen to another user...its likely a defect in the way the camera was sealed at the factory...
 
You must log in or register to reply here.
Top Bottom