dahua

  1. davidbann

    Network Firewall Rules for Dahua Remote Access

    Hi all, I am busy securing my camera network. I have put my NVR, cameras, VTO and VTH on their own VLAN without internet access. I have managed to get them all working on the local network, but now I want to get the DMSS app to work remotely so that I can view the cameras remotely, and so...
  2. O

    DAHUA Can't see the camera preview because of the certificate, NVR not loading after setting https

    Hello, I have an issue. Some of the cameras that my company uses require to install a certificate even though it is installed. I tried the solution with setting the NVR to https and after that the site doesn't load. Multiple NVRs have similar issue, alas they are scattered around the country so...
  3. M

    Balanced Dahua night settings

    Hi. I am a new Dahua users. I have a bunch of the 4Mp wiz color night color cameras. I am curious if there are optimal balanced settings for night color cameras? On one hand I like the visibility but then if someone walks by the camera their face gets blurry. I have found articles where I mess...
  4. R

    WTS Non-working Outdoor security camera Dahua Network PTZ DH-SD59430U-HNI $75

    Camera is in excellent condition (never ran it in survey mode, just manually positioned very rarely to focus on parts of pond animals were getting into. Does full start up (all the motions to set up position encoders) but stopped communicating on Ethernet. Has original power supply. An...
  5. Nighthawk37

    Dahua / DMSS playback issues

    Hello. I've noticed a strange problem. I have been getting notifications of motion from my Homekit (via scrypted) but not DMSS. When i log into DMSS to check why, i am noting no events for that time period and when i try to play, it literally jumps over it and goes back 30+ minutes... like the...
  6. iSnapper3000

    Setting Up a Firewall for Dahua PTZ — Is an Isolated Subnetwork Necessary?

    I'm looking into setting up a firewall for our Dahua PTZ unit. I want to make sure it’s protected from the main network it’s currently hosted on. From what I understand, we’d need to create our own subnetwork, which is then protected independently. We would block any inbound connections, and the...
  7. Nighthawk37

    New Dahua UI motion / VCA setup question

    For the newer Dahua cameras with the updated UI, i have a quesiton regarding motion detection. With the old Dahua UI I have IVR setup with trip wire and all of that. I have that as well this time although the settings are labeled a little different. It's under VCA settings (under smart...
  8. C

    RTSP stream of all channels grid from Dahua NVR?

    Hi, Is it possible for the current Dahua NVRs to stream a grid of all channels on an rtsp url? I can do this on Hikvision NVRs for displaying a grid to home automation touchscreens and then touching the area for each channel loads the full screen rtsp for that channel, but I know this isn't a...
  9. Nighthawk37

    EmpireTech NVR / Camera Tripwire / motion settings?

    I'm not sure if this is technically an NVR question or a camera question but i received my NVR16CH-16P-2XI and Color IPC-4k cameras. I get that these are supposed to be white-labeled Dahua cameras but overall this feels like a huge step backwards. The first thing i noticed is that as soon as i...
  10. S

    Help me choose between these cams?

    Need a little help deciding. — Dahua vs Hikvision + one 180° cam? • All rounder + low light performance? Dahua IPC-HDW5859H-ZE-PV-PRO or Hikvision DS-2CD2387G3-LIS2UY/SL and one 180° cam: Hikvision DS-2CD2387G2P-LSU/SL or Dahua IPC-PDW3849-A180-AS-PV
  11. I

    Alternative 1/1.8" Sensor option for IP camera in Australia

    Just looking if anyone has any alternatives in the Australian market to the 5442 range of Dahua & 2CD3267G3 Hikvision cameras that have a 1/1.8" sensor & IR or multi light not just white light for illumination. Looking to put together a 3 - 4 camera system all outside with only 1 having a sensor...
  12. Nighthawk37

    Dahua v5 upgrade questions / Empiretech Taurus

    Hi. I just received my new empiretech gear and was wanting to upgrade to Dahua v5. I started looking up firmware updates and model numbers and noticed that Empiretech firmware is from "Taurus Platform". Is this a replacement for the Dahua UI? Or a rebranded firmware? Either way, is it possible...
  13. Nighthawk37

    Upgrading dahua NVR - swapping hard drives

    I just got a shiny new NVR. I have a 4tb premium drive in my old NVR and was going to take the drive out and swap it. Do I need to format it, or do anything special ? Or will the NVR prompt me to do everything
  14. wall46

    ANPVIZ

    I'm a BI user for a very long time. Actual equipment (W10pro, 64GB RAM, 24" ACER 2560x1440 ) 1 Gbi CAT5 LAN w/ POE switch for 2 brandnew ANPVIZ uprime PTZ "ANPVIZ PTZ30A60WD-SA-5X(A)" and 2 seasoned DAHUA SD-22204. The Dahua's working after a long time of crying and praying. :cool: Dahua's...
  15. W

    Dahua - NVR4108HS-4KS3 Custom RTSP Help

    Hey all, i bought this NVR4108HS-4KS3 and it is missing the Custom add option to add RTSP Camera. Is there a hack or custom firmware i can use to enable that? Please help
  16. J

    Dahua / Empiretech IVS feed with Blue Iris - missing ONVIF source data field

    I struggled for 10+ hours to get IVS from my Empiretech/Dahua camera to feed properly into Blue Iris. I finally figured out the issue, so I thought I would share it here. The key thing I missed (and didn't see in the dozen or so other forum threads) was that I needed to add "00000" to the ONVIF...
  17. maxromanovsky

    Difference between Dahua VTO2202F-P-S3 and VTO2201F-P-S2 intercoms

    Is there any difference feature-wise between Dahua VTO2202F-P-S3 and VTO2201F-P-S2 intercoms? Both of them are not EOL. From what I could find, VTO2202F-P-S3 supports: 2-wire newer firmware (and might be more complex to setup without VTH) Other than that, they seem to be identical.
  18. ExpandoObject

    DH-IPC-HDW3649H-AS-PV-ANZ Stuck on Firmware Upgrade

    Hi, Beginner here, was upgrading my camera and it got stuck. I rebooted and lost access to it. Have tried everything I could from using config tool to TFTPD but no luck. It boots up and sets itself to 192.168.1.108. If I set the same IP to my PC, the IP changes so assuming its boot loader is...
  19. S

    Dahua IPC-HDW1639T not getting IP from dhcp

    I've just acquired a new IPC-HDW1639T which I've tried to test and configure before installation. It appears to power up (white LED comes on then goes off) and its MAC address appears on the LAN. But it doesn't appear to be requesting or receiving an IP address: the dhcp server doesn't log any...
  20. B

    My 9+ Year Journey For Accurate CCTV Alerts

    Nine years ago, I hired a security installer from Yelp who recommended 14 basic 4MP cameras from ENS Security (IP-5IR4002VFZ-W) and two PTZ cameras (IP-5PT96E2IR20X) for my home. The system was simple, lacking “smart” features, and its motion detection was unreliable, constantly triggered by...
  21. M

    Can WizSense DVR provide human/vehicle detection with regular HDCVI cameras?

    Hi, I’m trying to understand how Dahua smart detection works. Specifically, I’d like to know: Can a WizSense DVR perform human and vehicle classification using standard analog HDCVI cameras? Or do I need to use WizSense IP cameras to get accurate detection and push notifications only for...
  22. E

    Hik NVR struggling to record RTSP streams reliably from certain cameras

    Got a problem which currently has me stumped. At a remote site, I have a typical PoE NVR, which is branded as SPRO, but I believe it is a re-branded Dahua unit. Connected to this NVR are some 10 IP cameras. I did not install this system myself, but rather inherited it, so I cannot explain why...
  23. M

    Problem with DAHUA PTZ DH-SD59430U-HNI black screen random.

    Hello, The problem with the IP camera is as follows. At first, the camera shows a normal image when it is first turned on (it has not yet warmed up that much). The room I am testing the camera in is about 25C. Sometimes it can work for days, and sometimes after 20 minutes it starts to show a...
  24. M

    UNIFI—The Best Option...?

    Hear me out... drop the pitch-fork! :) For people like me that don't have the time to fiddle with things and need them to work for years on end and with remote management and remote firmware updates that work out of the box... it seems like UNIFI protect is the way to go. Yes, my Dahua Turret...
  25. Wenzo

    DAHUA VTH5341G-W showing the Video feed of DAHUA VTO1201G-P doorbell but not calling

    Hello everyone, I just bought a Dahua VTO doorbell and I connected it to my network using a PoE switch. My VTH already exists on the network. Everything was setup but I can only see the video feed from the doorbell I’m not able to call. Please help
  26. M

    Dahua NVR NEXT GUI

    Lads, Dahua releasing an entirely new GUI for NVR's. Doesnt look bad, hopefully its better than the recent "AIoT" menu they brought out on EI models. https://www.dahuasecurity.com/Products/keyTechnologies/1115
  27. sejohnny

    3 Dahua NVR's between buildings: guy on NVR #1 wants to see cameras on #2 & #3

    Guy on NVR #1 wants to see NVR #2 & #3s cameras on NVR #1. Can't go on the internet. the buildings already have ubnt nano stations between them just for our stuff. What's the best way to put the other two NVRs cameras on NVR #1? Thank you.
  28. Ollie

    smart pss - events' history removed after restart

    Hi, For those who are still using Smart PSS; After restarting the application, all events disappear and an empty list is shown. Is there a configuration setting that allows the application to retain events after a restart?
  29. 7

    what are box cameras used for?

    i want to install ip cam on top of the cash register area. most people recommended varifocal cams. i had in hand 2mp dahua varifocal 2.8 to 12mm outdoor model (DH-IPC-HFW2231T-ZS-S2) but not very satisfied with the video quality. Box cameras caught my attention with high frame rate. not sure if...
  30. poxyran

    Dahua Camera CPU ???

    Hello!, I'm new here!. I'm researching a Dahua camera and I found a chip after removing the heat sink and thermal paste I don't information at all. It has the following information printed in the chip "YL8553A". Does anyone have any idea what it is? I couldn't find any information about it...