Not getting clips in BI from Empire Tech cams!

E

Evroul

Getting the hang of it
Dec 25, 2023
95
71
Denmark
Hello all, decided to revive my NVR solution after some rather annoying experiences with our local security firm. ( Prices )
Well I have set up BI, removed auth in network settings on cam ( just testing one in BI demo ), I can see the intrusion zone go from blue to red as the wife and dog enters. Som camera fires
I have get onvif turned on, I have continious + sub on, no motion only get external and onfiv under alert.

I dunno whats going on. Is my firmware too old on andys cams? ( 4 years old app )

I have 8 EmpireTech IPC-T54IR-ZE-S3

Worked like a charm years ago - was set and forget

Any help is greatly appreciated

Happy new year to all

Brgds
Henrik
 

Attachments

  • 1.png
    1.png
    52.1 KB · Views: 17
  • 2.png
    2.png
    79 KB · Views: 16
  • 4.png
    4.png
    34.4 KB · Views: 18
  • 5.png
    5.png
    4.6 MB · Views: 19
  • 6.png
    6.png
    45.4 KB · Views: 18
  • 7.png
    7.png
    272.2 KB · Views: 16
  • 8.png
    8.png
    144.2 KB · Views: 17
  • 9.png
    9.png
    276 KB · Views: 17
  • 10.png
    10.png
    16.9 KB · Views: 18
  • 11.png
    11.png
    44 KB · Views: 19
  • 13.png
    13.png
    3.5 MB · Views: 19
Go to camera setting and hit the find/inspect button and post what pops up in the window.

Some of the cameras, BI will throw that error for a few minutes before it starts receiving ONVIF calls, so see if it resolves after a few minutes.
 
Well I took a shortcut and used BI’s own detection and it works like a charm. I remember though you at some point said the IVS system in the cams are better at the job. I also tried ( and yes you can booh at me ) frigate briefly but to get a notification on my phone I had to install frigate, passthrough my coral usb in proxmox, install Home Assistant, set up mqtt, edit configuration.yaml to accept my reverse proxy from Caddy and wireguard I use home through MikroTik… just to get a snapshot … and still it doesn’t show a clip… blue iris just works! Still I’m puzzled why the ivs I set up doesn’t get sent to BI. If I were to try to update my firmware on the cams ( it’s from 2023 ) would they default to 193.168.1.88? I’m running them on vlan50 with no dns access now for well obvious reasons . Thx for helping @wittaj
 
You must log in or register to reply here.
Top Bottom