Recent content by Coal_Cracker

  1. Coal_Cracker

    Config tool site not secure issue

    You were 100% correct it was an IP address conflict. I logged on to my router client list and I had two devices with the same IP address. It's just so hard to do much troubleshooting with my little ones around on the weekends. I knew it was something simple I messed up on setup. Now I can test...
  2. Coal_Cracker

    B54PRO-Z4E first impression

    I’m still on the 8/27
  3. Coal_Cracker

    Config tool site not secure issue

    I don't install them until I have them setup. I leave a length of cable off the switch for whatever I need to plug in randomly.
  4. Coal_Cracker

    Config tool site not secure issue

    TP Link TL-SL1218MP PoE power budget with up to 30 W for each PoE port and 250 W for all PoE ports. I have 7 cams on it. 3 5442T ZE, 2 E3241F-AS, 1 boobie cam, 1 T54Pro -ZE
  5. Coal_Cracker

    B54PRO-Z4E first impression

    @tmxv4128 So I went into my settings on my other cams and mine were very close to what you posted. My gamma was a bit lower and my sharpness a bit higher everything else was very similar. Probably just personal preference. bumping the gamma did lighten everything up a bit though.
  6. Coal_Cracker

    Config tool site not secure issue

    I got you now. I’ll see if I can give it a go.
  7. Coal_Cracker

    B54PRO-Z4E first impression

    Thanks, this will give me a good baseline to start with.
  8. Coal_Cracker

    B54PRO-Z4E first impression

    @tmxv4128 What settings are you using for night? I just put one of these cams online yesterday and haven't got to play around with it yet. Hopefully tonight I will start tweeking it.
  9. Coal_Cracker

    Config tool site not secure issue

    I did try switching cables after I posted before, same issue. I don't really have any interest in running a separate 12 volt I bought a good switch so I didn't have to deal with running multiple wires. So do you think the camera is bad then? Its brand new I just got it delivered this week.
  10. Coal_Cracker

    Config tool site not secure issue

    Config tool is the setup app for the cameras. So it sounds like it is defiantly boot looping. I had to run out for a couple hours when I got back I hard reset the camera and re configured again thinking I made some sort of mistake on setup. Got it setup on the network and it was still restarting...
  11. Coal_Cracker

    Config tool site not secure issue

    I'm trying to set up a T54IR as s3 and when I'm in config tool it keeps logging me out almost instantly. Edge is saying site is not secure. Last night I set another new cam up with no problems. What gives?
  12. Coal_Cracker

    Camera side RJ-45 wire sequence

    Well the fix worked, camera back online.
  13. Coal_Cracker

    Camera side RJ-45 wire sequence

    So I dug in a little deeper and discovered that the brown and blue are connected to two of the prongs. What do you make of that @tigerwillow1
  14. Coal_Cracker

    Camera side RJ-45 wire sequence

    LOL. No, there was a plastic heat molded insulator there. I tried gently pulling the insulator off first before cutting it, as soon as I saw it was pulling the wire insulator with it I stopped and cut it off.
  15. Coal_Cracker

    Camera side RJ-45 wire sequence

    Patience little? Yes. So here is the sequence of the wires. Now this is for the T5442T-ZE others may possibly be different. Take note the contacts are down in this picture.
See more
Top Bottom