Hikvision g6 V5.8.30 firmware for DS-2CD1067G2-L IP camera

saleh.poushesh

saleh.poushesh

n3wb
Mar 11, 2020
2
0
Europe
Hi
I need to download the DS-2CD1067G2-L camera firmware, but there is no firmware on the global Hikvision website.
By chance, I found a release note file for the G6 V5.8.30 firmware and saw that it was also the DS-2CD1067G2-L model in the list of supported models. I uploaded this file here as well.
The problem with cameras is that they don't store any settings. Any settings, such as changing the IP, changing the password, etc. After turning it on and off, it will return to its previous state.
I REVERTED THE CAMERA TO FACTORY SETTINGS USING UART, BUT NOW EVERY TIME THE CAMERA RESTARTS, IT'S INACTIVE.
I'm sure this problem has nothing to do with the power outage. Even when I restart the camera via UART and don't unplug the power, the camera still reverts to the default settings.
Thank you for helping me
 

Attachments

Thank you for your attention.

No, it's not a problem with the reset key.

Let me explain it completely and from the beginning.
They gave me 5 Hikvision DS-2CD1067G2-L cameras, which were already installed somewhere and worked properly. But later, when they wanted to change the NVR, they realized that any changes in the camera configuration would return to the previous state after it was turned off.
For example, a camera with IP 192.168.1.205 was connected to the previous NVR. But now that they want to connect the camera to the new NVR device with a different IP, even though the IP changes, it returns to the previous IP i.e. 192.168.1.205 after it is turned off.
As I said before, in the first step, I REVERTED THE CAMERA TO FACTORY SETTINGS USING UART, BUT NOW EVERY TIME THE CAMERA RESTARTS, IT'S INACTIVE again!

I THINK THIS PROBLEM CAN BE SOLVED WITH THE CORRECT FIRMWARE, BUT I CAN'T FIND ANY SUITABLE FIRMWARE.
 
saleh.poushesh said:
any changes in the camera configuration would return to the previous state after it was turned off.
Click to expand...
It sounds like the configuration is not able to be written to the flash memory when changes are saved.

A suggestion to try :
As you have access to the serial console via the UART connection, make a change to the configuration settings or network settings and observe what the serial console shows when 'save' is pressed.
Maybe there will be some clue there as to the cause of the problem.
 
You must log in or register to reply here.
Top Bottom