I was spending most of the day configuring a dual NIC setup, and putting my cameras on an isolated subnet. For some reason, one of my SD49425XB-HNR's had network access control on, restricting access to my main network. I only realized this after changing the IP of the camera to the new subnet. I can ping it, but now I can't access it. Short of climbing up on the ladder and doing a factory reset, is there anything I can do to get into it? SSH was disabled before the change, so that's out the window too.
Unable to access camera after network change
- Thread starter mrc545
- Start date
Disregard. Took a laptop to the switch and added a static route in Windows to allow the primary network to access the camera.
