Does anyone know the name of, or where I can buy the special wrench needed to tighten and lock the dahua cameras into place? Different models might have different wrenches, but does anyone know the name of the style/genre so that I can order a set on amazon or something? It doesn't look like a standard tension wrench
dahua wrench to tighen/untighten?
- Thread starter bc99
- Start date
They look like regular Torx bits. Found a kit on Amazon.
https://www.amazon.com/Piece-Securi...t=&hvlocphy=9003363&hvtargid=pla-571295460461
https://www.amazon.com/Piece-Securi...t=&hvlocphy=9003363&hvtargid=pla-571295460461
As an Amazon Associate IPCamTalk earns from qualifying purchases.
+1^^.
"Just received a Dahua IPC -T5442TM-AS Saturday from Andy and the included tool is same as my standard Torx T10 driver; the tool has a hole that a pin in the screw head would fit as many anti-tamper screws are, but your T10 will not need the hole, as the cam's screw did NOT have pin in it (at least mine didn't and I haven't seen a cam yet that did require the hole in the end of the bit).
So a standard T10 Torx should fit."
Edited 8/24: Torx driver or bit should be T10.
"Just received a Dahua IPC -T5442TM-AS Saturday from Andy and the included tool is same as my standard Torx T10 driver; the tool has a hole that a pin in the screw head would fit as many anti-tamper screws are, but your T10 will not need the hole, as the cam's screw did NOT have pin in it (at least mine didn't and I haven't seen a cam yet that did require the hole in the end of the bit).
So a standard T10 Torx should fit."
Edited 8/24: Torx driver or bit should be T10.
Last edited: