Bricked Hikvision DS-7204HQHI-K1 - UBOOT BRICK

R

resistbody

n3wb
Apr 21, 2020
2
0
BG
Hi, I've bought 2 dvr form ebay, one did not start other has passsword. With help form here I've changed firmware and now it its clean.
Other have more serious problem.
After power ON, it shows

U-Boot 2010.06-svn (Apr 20 2017 - 14:24:06)[V1.4.5]

d▒ta▒▒bo▒▒
data▒▒bo▒▒

and freezes...
some times it goes to

data abo▒▒
data abort
pc : [<8dc01454>] lr : [<8dc0bbb4>]
sp : 8d9ffe58 i▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒▒prefetch abort
pc : [<00000002>] lr : [<8dc09d04>]
sp : 8d9ff938 ip : 00000030 fp : ffff0000
r10: 0000008d r9 : 00000000 r8 : 8d9fffe0
r7 : 12040050 r6 : 8dc348a8 r5 : a00001d3 r4 : ffffffff
r3 : 12080000 r2 : 0000010e r1 : 0000000d r0 : 00000000
Flags: nZCv IRQs on FIQs on Mode SVC_32
Resetting CPU ...

and freezes

I think problem is in Uboot loader... do you think it could be fixed by TTL or other NO soldering way

Have someone had same issue ??

p.s.Sorry for my bad english.
 
resistbody said:
I think problem is in Uboot loader... do you think it could be fixed by TTL or other NO soldering way
Click to expand...
If you can't get a working bootloader there are not many options.
At a lower level ther may be the fastboot facility - but that may not exist and would need knowledge and possible mods to the board hardware.

How repeatable is the detail in the abort trace? If it's the same each time, it may be corrupted flash data.

If the problem is caused by corrupted data in the flash chip, as opposed another hardware fault -
One possible route might be to check out the flash chip and if it is an SOP-8 or SOP-16 type of package an in-situ re-flash might work.
This would need a suitable 'test clip' for the part number, and a flash programmer, both of which cost very little.
It would take time though.
One out of 2 isn't bad, depending on what you paid for them.
 
You must log in or register to reply here.
Top Bottom