Search results

  1. ebelew

    IP Bullett keeps dropping

    This is the camera in the other thread that I can't find a reset button. I own a couple bullet cameras (different types) but this one doesn't have a card slot or a button close to it. I'm going to start pulling it apart soon. Maybe then.
  2. ebelew

    IP Bullett keeps dropping

    Actually it's never connected. On the NVE software when I plug it up Status will read "Detecting" for a little, then show the triangle for "destination couldn't be reached" back to "Detecting. Any ideas where I start?
  3. ebelew

    Reset DS-2CD8254FWD-EIZ

    I just ran across one of these and need to reset it to factory defaults. I do not find a reset button to push and hold like I did on my other cameras. Am I overlooking it or trying to do it wrong?
  4. ebelew

    Wired only access with DS-7616NI-E2/16P

    Great it wasn't exactly that but close enough. My AP is not part of the router. I am running a single SSID but it had what is called a "Wireless Security Filter" section within the SSID configuration and a box was check that "Restrict wireless traffic to:" the AP itself. Once logged into the AP...
  5. ebelew

    Wired only access with DS-7616NI-E2/16P

    I've got the NVR going on the wired local LAN. I can type in the IP address in Safari and IE and web interface let's me log in and see everything. On an iMac when it wired to the LAN everything works. When I unplug the network cable and use wireless it can't connect to the NVR, although all...
  6. ebelew

    HIKVision Network IP (IPs) question

    You guys are correct. The upper IP is for managing on you network and the lower is to assign IP to the camera. I just spent a long time putting my NVR at 192.168.*.* and the lower IP at 10.10.10.* I then went through an changed all my camera IP's to match the 192.168.*.* scheme. Power went out...
  7. ebelew

    HIKVision Network IP (IPs) question

    Sorry, This is on the NVR itself, not the cameras. Would that matter.
  8. ebelew

    HIKVision Network IP (IPs) question

    I'm setting up a new NVR (DS-7616NI-E2/16P). I need it on my network with a static IP. In the Config menu there seems to be 2 fields for IPv4 address. It will not let me put them in the same range. It gives me an error message and then defaults the top IP to 192.0.0.64 Which one needs the...
Top Bottom