Open the web ui of the NVR, (use IE), then Settings, Camera, on the right of each camera,you should see the link for access the camera via its gui, on the NVR, make sure that under Settings, Network, TCP/IP , virtual host (at the bottom) is checked.
IIRC, with older firmwares, admin/admin, otherwise, after a factory reset, the camera should be re-initialized, and should ask you to create the password
Sure that the firmware is for these models ? The 0620 is DH_IPC-HX5XXX-Volt_MultiLang_NP_Stream3_V2.800.0000000.17.R.200620.bin, while the 0717 is General_IPC-HX5XXX-Volt-MCU_V2.800.12JW000.0.R.200717.bin
Si, puoi installare la nuova versone, ma se scrivi in Italiano, dubito che Andy ti risponda ... :)
Yes, you can upgrade to the new version, side note, if you write in Italian, I doubt that Andy will respond ...
I have to agree with the previous comments, I 've a couple of 8232E-ZE, and some 5442E-ZE/5442TM-AS, and honestly, I find, overall, better the second ones (the 7442 is even better ... :) )
@Slacker Did you see any improvement, somewhere ? I were a bit worried about upgrading my 7442, since on the website, is clearly stated that this fw is for 7842 (even if, usually, are the same) ....