Toolbelt's latest activity
-
TNot sure I completely agree with this but I did spit some coffee out laughing when I saw it.
-
TToolbelt replied to the thread PTZ focus stuck.Surprisingly, there is very little info on the web about repairing/replacing components on security cameras. I assume a lot just get...
-
TToolbelt replied to the thread PTZ focus stuck.I used the IR cut filter that came attached to the new lens, however, I believe it's slightly taller than the original, which is...
-
TToolbelt replied to the thread PTZ focus stuck.Well I replaced the lens assembly on the image sensor board (which is mounted using 2 screws, and plugged in the two board connectors)...
-
-
TToolbelt replied to the thread Is the regime in Iran soon to be toast?.Somehow, that's actually believable at this point. lol
-
TToolbelt replied to the thread Is the regime in Iran soon to be toast?.I don't think anybody expects them to go head-to-head, so they use terrorism for leverage.
-
TToolbelt replied to the thread Should Importers get a REFUND of Tariffs struck down by SCOTUS?.Agreed. Each level should get a refund. But only if importers/retailers can prove they've issued refunds to consumers. It's going to...
-
TToolbelt reacted to Timokreon's post in the thread Should Importers get a REFUND of Tariffs struck down by SCOTUS? with
Like.
Should they be given? Yes to the consumers. Problem is, we the people already paid the TAXES or as Trump calls them tariffs, if any... -
TToolbelt reacted to Ssayer's post in the thread Should Importers get a REFUND of Tariffs struck down by SCOTUS? with Like.
If there IS a refund to be given, it should be to the consumer as it's the consumer that got stuck for the cost of the tariff..
-
TProsecute those in NO police department who knowingly broke the law. Some people in this country are a bit too bold and in your face...
-
TToolbelt replied to the thread PTZ focus stuck.Assuming I'm not changing the image sensor, which I assume was designed for the original 2 MP lens, will "upgrading" to the 5 MP lens...
-
TToolbelt replied to the thread PTZ focus stuck.I finally took it down and opened it up. There's 2-3 worn teeth on the focusing ring near the end of its travel so I may try to form...
-
-
TI would wait until it warms up, and NOT be messing with trying to focus until it does warm up, to prevent further possible damage.
-
TI have a Hosafe PTZ security camera, and during a recent cold snap, the focus froze or stuck. I've tried manually adjusting the focus...
