Recent content by R@lKan

  1. R@lKan

    Need help figuring out the ports on the back of the NVR for the building alarm...

    after the reboot its only one I'm having the issue with and its one that's directly connected to the ports on the back of the nvr, not one I pulled from the network...
  2. R@lKan

    Need help figuring out the ports on the back of the NVR for the building alarm...

    ok, so I connected it via 12v out on panel to port one, the ground to the ground on the panel and set it to NC, 2/15 cameras once the alarm setting was enabled stay recording and I'm not sure what the deal is with that....if I switch it to NO all of them except those two stay...
  3. R@lKan

    Need help figuring out the ports on the back of the NVR for the building alarm...

    heres what I'm working with
  4. R@lKan

    Need help figuring out the ports on the back of the NVR for the building alarm...

    ill try and post a pic in just a min so u can see what I'm looking at too
  5. R@lKan

    Need help figuring out the ports on the back of the NVR for the building alarm...

    there are 6 input ports across the top and 6 across the bottom one row NC one row NO I just don't know which numbered port to connect the + wire to from the alarm panel....ideally I'm wanting to run the + wire from one of the siren connection ports into the nvr so that anytime the alarm is going...
  6. R@lKan

    Need help figuring out the ports on the back of the NVR for the building alarm...

    I have an nvr5232 setup with 15 cameras and motion detection set to be recorded times, Im trying to find out the best way to connect the building alarm to the NVR in the back so that if the alarm is tripped all the cams start a record session....on the alarm panel i have identified all the...
See more
Top Bottom