Recent content by katnelson7175

  1. K

    Alarm Output Rating

    Here's another solution to the CTRL P (Normally Closed Relay) Disregard the load illustration above for the photo sensor output....use this below instead and you changed a NC relay to an NO relay. :) https://www.amazon.com/gp/product/B08343R8YQ/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1...
  2. K

    Alarm Output Rating

    So what you do is: get a 12v female barrel plug pigtail. Tin your red wire on the pigtail. snip it off a little bit snip your zener diode smaller and tin both sides solder the red wire from it to the zener diode. (making sure the black line is facing away from the red wire. You solder a small...
  3. K

    Alarm Output Rating

    No1 and C1 = Alarm 1 CTRL and P = Alarm 2 What happens if you take a multi tester that's capable and touch both leads to a piece of copper wire with the tester set on conductivity.....you will get a beep. So what I did was connect a black wire to CTRL and a red wire to P and connected my probes...
  4. K

    Amcrest NV4232E-16P-EI

    Removed the pluggable block for NO1 C1 GND 1 2 GND and tested on GND with my multitester (-) lead and (+) lead to P It is confirmed without anything else hooked up 12v+
  5. K

    Amcrest NV4232E-16P-EI

    https://ipcamtalk.com/threads/alarm-output-rating.71447/ In manual it says CTRL is "Controllable 12 V power output. It is to control the on-off alarm relay output. It can be used to control the device alarm output. At the same time, it can also be used as the power input source of some devices...
  6. K

    Amcrest NV4232E-16P-EI

    My alarm block looks like this: NO1 C1 GND 1 2 GND CTRL P GND 3 4 GND My current setup is 12v 1 amp power supply (+) to alarm siren (+) and (-) from power supply to NO1 with (-) from siren to C1. My specs sheet says it has 2 alarm outputs and 4 inputs. What I'm seeing is if I...
See more
Top Bottom