Recent content by jelf4352

  1. J

    Clicking Noise from WD Purple?

    Anyone else have clicking noises like a heartbeat when recording to WD Purple? Im starting to find it annoying and im wondering if its normal. Thanks,
  2. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    do you apply to both sides? or just camera side? i actually didnt use it so thats probably part of the reason too.... i guess i got lucky at my second home where i didnt use it since and barely have signal loss.
  3. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    Quick update: I cut off about a foot on each side of each cable and put on new connectors. It’s been almost a week with signal loss only 4 times on one camera over the span of 5 minutes. Part from that one off occurrence it’s working all good now. So….its the cable/connector.
  4. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    I have blue iris setup on a PC and a dual NIC card with Internet one and cameras via a switch on the other
  5. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    Yes, here you go....They are all down right now probably for the same reason why some of the cameras go down....still trying to figure it all out.
  6. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    Thanks....I will try this method to try to identify the issue. These are the cat5 cables and connectors that I used. Does anything seem wrong? Everest Cat5e RJ45 Pass Through Connector 50-Pack - EZ Cat 5e Pass Through RJ45 Connectors - Cat 5e Connectors - Ethernet Connector, Ethernet Plug -...
  7. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    It’s pretty frustratinng….im not sure why it’s only on 2 of my cameras. I have the exact same setup at my other house and all my cameras have worked flawlessly forever. I’m about give up …it makes having cameras at this place kind of pointless if I can’t rely on signal
  8. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    yea the two cameras are actually on different power sources. i have two switches.
  9. J

    My camera drops sending signal around 2pm everyday and comes back on around 6pm. See Pics.

    Like the tile says, my camera drops signal for 4 hours everday around the same time. I check the switch and the green power light is on but the orange light is NOT on. It restores itself about 4 hours later. Now a second camera has started behaving like this and has dropped signal for days. It...
  10. J

    How to wire cameras? Wrap cable around house? In/Out through venting?

    Great thanks, very helpful. So I did find some cat5 cables that went out to home run box close the garage. It’s the brown box under the electrical box. This gets me much closer to the garage and then all I would do is wire from that area to the white door in the second picture. Thoughts? I would...
  11. J

    How to wire cameras? Wrap cable around house? In/Out through venting?

    there is a space to enter the attic. Most of my camera installs are where the roof meet the wall, so the space is very small there like a tight triangle. The only way to tell is to just drill and hope i enter the attic? And then i somehow push the cable through enough that i can grab it on the...
  12. J

    How to wire cameras? Wrap cable around house? In/Out through venting?

    I've seen a few soffit posts, but i don't believe i actually have soffit? See pictures below. It just seems like the roof extends over the house. How do i enter my attic? I've seen other wires on my house exit the attic on the side of the house through venting and just wrap around - it makes...
  13. J

    Move PTZ to presets based on specific triggered IVS rules of another camera

    I thought the IVS rules to trigger certain actions would work really well and was excited about it. But if I have 2-3 IVS rules with different actions, I found it really hard to get working right. Instead, I use a combination of IVS rules and motion zones. I don't turn on motion triggering, but...
  14. J

    Move PTZ to presets based on specific triggered IVS rules of another camera

    OK, thanks. I thought the "additive" option would only capture new zones/additional sources, so i wouldnt think triggering the same IVS rule would be considered a new source. Ill try the intrusion.
  15. J

    Teaser Info and Mini Review - Empiretech B52IR-X3 Triple Lens Camera

    its the same camera you are replying to in the other thread right now about the PTZ preset and IVS rules :lol: I cant even see a difference when i walk by up close. ill try deleting and re-adding.
See more
Top Bottom