Recent content by geerman

  1. G

    Multi Lorex Camera Install through POE Switch

    I am getting power to all of the cameras using the CAT 6 pre-wired to outside of house. One camera loses power after about 10-15 seconds. Not sure on that one? Although I am getting power, I am not getting image nor is the NVR detecting for 2 cameras. I also noticed that although I am getting...
  2. G

    Multi Lorex Camera Install through POE Switch

    So I did a bit more trouble shooting. I tested all cameras for image and power using a direct line to the switch with a Lorex cable. The 3 remaining cameras all work using this method; however, when I connect to pre-wired CAT 6 cable I get power (with the 2 Lorex bullets), but no image. The NVR...
  3. G

    Multi Lorex Camera Install through POE Switch

    I received my new POE switch. I managed to get 5 of 8 cameras working to show on Lorex NVR. So, making progress. Of the 3, not working: one of the LAN plugs electricians did not wire, 1 camera not seeming to get power and one Bullet camera getting power, but no image? My NVR can not detect the...
  4. G

    Multi Lorex Camera Install through POE Switch

    Thanks for the info. I did just noticed that the D-link POE 24 port unmanaged switch I received was actually a normal switch(non-POE). You think I would have recognized that immediately. That's what happens when you build a house. Time to get out of the Fog :). I assume that could be the biggest...
  5. G

    Multi Lorex Camera Install through POE Switch

    Hi all, Just built a house and had electricians use Cat 6 cable to pre-wire from chosen camera locations as I was concerned that the Lorex supplied CAT 5 cable would not be long enough. I purchased a D-link 24 port unmanaged POE switch. I have 8 Lorex cameras directly wired into utility room...
See more
Top Bottom