brokenarrow351's latest activity
-
BYou do have a separate night profile right?
-
BYes just older Firmware You shouldn’t need that much NR during the day. Back it down to say 30-35 NR creates motion blur
-
BHI @brokenarrow351 Yes, too little pixel density at that distance ( wide FOV camera, 2.8mm lens ) See the DORI section of the cliff...
-
BThe ZE would be good out to 25-30ish feet, so an improvement over the 2.8 but just not quite enough
-
Bbrokenarrow351 replied to the thread Am I expecting too much?.I do, though day/night settings in the exposure tab were the same. I changed the day settings to what you had. What do you have for night?
-
Bbrokenarrow351 replied to the thread Am I expecting too much?.My interface looks a little different, I'm assuming just software level differences. I don't have 3D/2D NR Level settings however. Also...
-
-
Bbrokenarrow351 replied to the thread Am I expecting too much?.Thanks for the sanity check guys. I actually do have the 5442-Z4E that's been on my project list to setup as a plate camera. Out of...
-
B+1 above. At 55 feet you need the 5442-Z4E if you expect to be able to read that.
-
BAt 55ft with a fixed wide angle 2.8mm lens? Yes That said it could be better. What are your settings? To get in the ballpark try these...
-
BI got asked my a neighbor today to help identify a car that pulled up to their house and was acting suspicious. The car had a sign on...
-
