bbwolfe's latest activity

  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Thank you. Found it!!!!
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Question about getting to files on the SD card. I have been spending my time getting the SD card installed, formatted, enabled and all...
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Here is a side issue I am experiencing. Attached is the "snapshot" directly from BI. It does not upload from my PC properly. The way...
    • Cam1.20250211_105847011.11.jpg
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    I am now trying to capture on the installed SD card (Transcend High Endurance 64GB 10 micro SD 1 XC I.
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Ok, this is an image set at 1/60 fixed and gain of 0-5. Yes, blurry. I will reset to early configuration that got me the best image so...
    • 2025-02-11_10-13-41.jpg
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    I think you are needing an image from an SD card, vs going through BI, correct? I will go and put an SD card in after correcting the...
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    I screwed up and see that the gain defaulted to 0-50. I will try again at 0-5.
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Do you have a recommended NVR? I've been using BI for years. My main reason is the ability to access the cameras and alerts on my...
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Done! Here is the new image at a closer zoom.
    • 2025-02-11_09-30-18.jpg
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Ok, done. I disabled substream and am only using the mainstream now.
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Holy smokes. I paid $429.95... before tax and shipping. Thank you!
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Oooh... No I have put on in but I will now! Thank you.
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    I sure hope I'm not frustrating you all. I know we are on the right track fixing this. All of these setting changes are new to me. I...
    • ki.jpg
    • kii.jpg
    • 2025-02-11_09-03-05.jpg
    • 2025-02-11_09-01-54.jpg
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Ok, I've disabled substream again and believe the next capture will be at 16,384 bit rate. Note: These are snapshots from pausing the...
    • 2025-02-11_08-42-55.jpg
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Here are the current encode settings. I see now that somehow the substream became enabled again. I had turned it off at the start of...
    • 2025-02-11_08-27-00.jpg
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    During all this work today, I made sure it was the main stream and had turned off sub-stream just to make perfectly sure. I will...
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Ok, here is the clearest image I have been able to get so far. (before and after) I will continue my quest. Thanks to everyone on this...
    • 2025-02-10_10-39-30.jpg
    • 2025-02-10_07-23-50.jpg
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    Thank you. I will try that in my upcoming sets of adjustment tests.
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    I only know it from this part #: Dahua Technology AcuPick N85FB6Z4 8MP
  • B
    bbwolfe replied to the thread Frustrate: Blur.....
    You folks are amazing. Thank you so much for this help. I am walking through each setting, one by one, trying to get as clear of an...