Recent content by artag
-
Reset link on XVR5104C-1TB
I'm looking for a reset link on this XVR - the board looks a lot like Reset password for Dahua DVR/NVR - NVR IPCAMERA SECURITY but there's a rearrangement that removes the button. There is a 3-pin connector in that area but it's not obvious that it's a replacement. I'd expect a reset link to be...- artag
- Thread
- Replies: 0
- Forum: NVR's, DVR's & Computers
-
PAL video output on BNC ?
I came to the conclusion that either the BNC connector on this camera is pointless (seems odd to have it ?) or that it's intended to be configured with the UTC protocol. One way to configure it is with an inline control box and the other is with a DVR. The inline box might be OK and are pretty... -
PAL video output on BNC ?
I'd already done a 'factory reset' using the button under the SD card access hatch - without that I wasn't able to find it's IP address. It was also ringing the alarm buzzer a few times on every power cycle making experiments annoying ! -
PAL video output on BNC ?
I'm away from home for a few days so I can't double-check but I tried all the suggestions from DahuaWiki rtsp:/192.168.2.128:554/cam/realmonitor?channel=1&subtype=0&unicast=true&proto=Onvif rtsp:/admin:[email protected]:554/cam/realmonitor?channel=1&subtype=1 rtsp:/192.168.2.128:554/live with... -
PAL video output on BNC ?
I found 'Web operation manual' which is a great help with general settings on the web interface, but doesn't mention the BNC connector. It does provide some information about RTSP but I haven't yet been able to make it work with VLC (even though there's a specific example !). -
PAL video output on BNC ?
I bought a DH-TPC-BF2221-HTM on ebay. Seems in perfect condition, probably never installed. I was able to get it running through the web interface thanks to a thread here about using edge in IE mode, but I'd like to have the plain old video mode through the BNC connector : I want to pass the...
