I tried to upgrade the Firmware on my hikvision DS-7604NI-E1 NVR with ver V3.3.1_150422. Actually the upgrade seem to work. Then I was required to put in a new password. I entered a pretty easy password and repeated it. It took. But, when I went to login again, I noticed the Username was an empty square and it will not recognize the password. Also I cannot see it anywhere on my network and it is not recognized by SADP tool or iVMS4200 tool. Is there anyway to reset the firmware or password without external tools. I am stuck. Here is a screen shot.
Hikvision NVR Firmware Upgrade / Password Problem
- Thread starter muddywaters7
- Start date
OK, I fixed finally fixed the issue. Used a crossover patch cord to connect to the NVR. Changed the my laptop address to 192.0.0.128. Finally, I could see the NVR AT 192.0.0.64. Downloaded the tftpserv from this location http://www.hikvision.com/europe/download_more.asp?id=1336p I put the 3.1.0 version of firmware in the same folder as the tftpserv.exe Then ran the ftfpserv.exe. I restarted the NVR and within 5 minutes the NVR showed the new password window. I made sure to not delete the username on the NVR and left the username as admin and changed the password. Then changed my laptop ip back to DHCP. I went back to the NVR and set a static IP. Made sure to disconnect the crossover patch cable and I was good to go. Typed the static IP address into my browser window and entered the username = admin and the password. All back to normal now.
whoslooking
IPCT Contributor
i had same problem , nvr nv3208hs-st hybrid analog/ip cameras , after upgrading to 3.3.4 ,user name is empty , but it will never log in , iam trying tfttp and i still get client failure any help