I need some help IDing a IP camera I can't for the life of me remember the brand and I need to reset it and set it back up it has been in a box for a couple years I am hoping someone can help me out on this I went so far as to open it up but there are no brands or anything on the PCB
need some help iding a cemera
- Thread starter Reginald Lewis
- Start date
look a like a rebranded Chinese generic camera. Probably, you will need to disassembly the camera in order to locate the reset pin. Usually is reset by grounding the pin next to the +vcc pin, located in the main board. A photo could help in order to identify the board type
a.aliexpress.com
12.87US $ 50% OFF|BESDER Audio Wifi Camera 1080P Wireless Alarm Push iCsee P2P 2MP CCTV Bullet Outdoor IP Camera With SD Card Slot Max 64GB| | - AliExpress
Smarter Shopping, Better Living! Aliexpress.com
a.aliexpress.com
Here is a photo of the board I can get better if needed there is a setup button on the power wire but I don't think it does a reset.
look a like a rebranded Chinese generic camera. Probably, you will need to disassembly the camera in order to locate the reset pin. Usually is reset by grounding the pin next to the +vcc pin, located in the main board. A photo could help in order to identify the board type
12.87US $ 50% OFF|BESDER Audio Wifi Camera 1080P Wireless Alarm Push iCsee P2P 2MP CCTV Bullet Outdoor IP Camera With SD Card Slot Max 64GB| | - AliExpress
Smarter Shopping, Better Living! Aliexpress.com
Attachments
EDIT: you posted right before I did about the button on the pigtail.
It is labeld setup on the button but it has no effect when used i have tried holdinh when powering up and pressing with it powered on
I take it that the cam doesn't come up with an IP that shows up in your router's DHCP and/or no IR LED's come on, etc.
I think I may have got it I decided to play with the pins coming from the power cable and I got it to reset not to see if i can get it configured
Not necessarily the same brand/model, but could provide some info
community.netcamstudio.com
BESDER 6004MW-I101 720P POE (Chinesium..)
Short review and some info. Bought these two very cheap ones from here. I bought two of the 48V PoE 720P + 6mm options Delivery from China to Norway was about two weeks, not bad. Comes in a box with a pretty useless manual. No software. The typical Chinesium Active-X pluggin that Only...
community.netcamstudio.com
you could also try the following reset procedure (AP mode using phone):
Q8: How to connect the camera with AP mode if 'Add My Device (recommended) can't connect the camera to my phone?
A8: Press the reset button three times in a row to enter AP mode, then connect your phone to a wifi hotspot begins with 'camera_', the password of the hotspot is '1234567890', then click 'Add My Device(AP mode) when connecting the camera to your phone.
Edit: it looks like the only way to reset this camera is through wifi connection, using AP mode. Remember to keep the camera connected (wired) to your router during this procedure
Q8: How to connect the camera with AP mode if 'Add My Device (recommended) can't connect the camera to my phone?
A8: Press the reset button three times in a row to enter AP mode, then connect your phone to a wifi hotspot begins with 'camera_', the password of the hotspot is '1234567890', then click 'Add My Device(AP mode) when connecting the camera to your phone.
Edit: it looks like the only way to reset this camera is through wifi connection, using AP mode. Remember to keep the camera connected (wired) to your router during this procedure
Last edited: