UniFi G6 Turret mounting hole spacing specs

S

ShawnB

n3wb
Mar 26, 2017
14
4
Does anyone have the mounting hole specs for the UniFi G6 turret mount (or presumably G5 turret, etc)? I haven't been able to find any Ubiquiti technical drawings with these specs.

I'm looking to setup a test rig once the G6 black turrets eventually ship, and would like to find a compatible Dahua wall mount or junction box, since I already have some installed and they are reasonably priced/available and good quality.

Thanks!
 
ShawnB said:
Does anyone have the mounting hole specs for the UniFi G6 turret mount (or presumably G5 turret, etc)? I haven't been able to find any Ubiquiti technical drawings with these specs.

I'm looking to setup a test rig once the G6 black turrets eventually ship, and would like to find a compatible Dahua wall mount or junction box, since I already have some installed and they are reasonably priced/available and good quality.

Thanks!
Click to expand...
I have a G6 turret. The mount uses 4 screws. If you draw a line from one screw to the one on the opposite side it measures 2 3/4". If you draw a box and measure the four sides each side is 1 15/16".
 
  • Like
Reactions: ShawnB
I finally got around to testing some mounts. The G6 turret appears to have 4 holes in a square pattern on a 70mm diameter. Dahua typically uses 3 holes, but the PFA130-E junction and PFB205W-E wall mount have a 4-hole pattern at 68.5mm diameter.

The path of least resistance was to drill out the holes slightly in the G6 base, to a 7/32" bit (from the original 5/32"), which created just enough space to use the 4 Dahua M4 screws. The screw head fits nicely into the recessed holes of the G6 mount, and the camera secures well to the mount.
 
You must log in or register to reply here.
Top Bottom