I have a Dahua DH-SD59432XA-HNR that the IR stopped working after 4 years. I have tried rebooting and resetting but just can barely see the IR on. So I was hoping to find a repair shop.
Dahua repair in USA
- Thread starter ponyrider127
- Start date
tibimakai
Known around here
It could be some shorted SMD capacitor. You could test them with an multimeter.
Install an exterior better IR light.
Install an exterior better IR light.
I was thinking about that but now motion is no longer working either, just 24/7 recording.
tibimakai
Known around here
tibimakai
Known around here
Parley
Known around here
The 24 VAC is through the separate power plug. However, it uses 12VDC through the POE cable. A lot of PTZs are configured this way. This particular PTZ uses 24W with the IR on. 11W without the IR off. That needs to be considered when selecting a power source.
All of the sprinkler controllers I've come across use a 24 vac supply, mostly plug-in transformers. Probably because the valves operate on 24 vac.
tibimakai
Known around here
tibimakai
Known around here
If that's the original box for the camera, that's quite an inexcusable discrepancy for the power spec. I wonder if the intent was to show that the power brick got plugged into AC, and whoever did the graphic for the box didn't understand the details? Never should have left the factory that way if it's incorrect.
